This is a library of perfboard and single-sided PCB effect layouts for guitar and bass. I'm not an electrical engineer by any stretch of the imagination, just a DIY'er who likes drawing layouts. It is meant for the hobbyist (so commercial use of any of these layout is not allowed without permission) and as a way to give back to the online DIY community.

Monday, April 27, 2015

Krank Distortus Maximus

This was a request. It's another 386-based distortion, similar in theory to the DAM Sonic Titan. Transistor-based "preamp" section which is amplified by the 386 "power" section, follwed by a 3-band tone stage on the output.



22 comments:

  1. https://www.youtube.com/watch?v=uA8_2ZRjS_U
    this is mine build!

    ReplyDelete
  2. you can see the demo https://www.youtube.com/watch?v=mFSUnGlAsqU

    ReplyDelete
  3. Mid, bass and treble don't work. Can someone help me?

    ReplyDelete
    Replies
    1. It could be any number of reasons. Got any pics of your board?

      Delete
    2. https://www.flickr.com/gp/136288675@N05/2v7453

      Delete
    3. I had forgotten to tell, some resistors were replaced. I used 39k in 43K, and 430K I used 390k. This could be the problem?
      (sorry for bad english, i'm using translator)

      Delete
    4. Can someone help me?

      Delete
    5. tengo el mismo problemas, lo pudiste solucionar?

      Delete
  4. which components are changed to transform into the ProTone Body Rot II ?

    ReplyDelete
    Replies
    1. Finally found a schematic of it, and while it's really close, the tone section is a bit different. So this layout won't work for it. I'll add it to the list though.

      Delete
  5. if the 4.2 mega in my place is hard to get, what can I use ... ??

    ReplyDelete
    Replies
    1. That's the pulldown resistor, so anything 1M or higher.

      Delete
  6. hey, has someone done it in pcb? which board dimensions did you use?

    ReplyDelete
  7. hello,bro.
    bass,mid,high could work
    but gain not work, is that lm386's problem?
    touch the input is same as ground

    thanks

    ReplyDelete
    Replies
    1. by the way, my LM386 is LM386 m-82 from China. need i change into LM386 n-3?

      Delete
  8. Hello.

    Does anyone know the dimensions of the pcb ?. They also have the list of components ?.

    Thanks from before hand.

    ReplyDelete
  9. Hello.

    Not the pdf in the dropbox folder. Does anyone know if it is saved under another name or where I can download it.

    Thanks in advance.

    ReplyDelete
  10. Hello!, thankyou for share these squematic, i need help about the how connect the potenciometers.

    ReplyDelete